LitePlacer.com forums

Hello again, During the last days I have done some more testing and calibration, following Juha’s advice trying to make the LitePlacer behave as supposed. The first test was to place a few targets on the table, five targets were used and three of them are still on the table as seen in figure 1 below...

Hello, People have been writing earlier in the forum about an X-axis offset, but I have not seen a solution to the problem. This is a long post (also my first) but I hope someone will read it and have some good ideas. I have finally finished my Liteplacer build and have a small offset problem. When ...