An offer to pay to make a universal feeder for PNP
Posted: Wed Jun 02, 2021 8:32 am
Hi All,
This is a bit of an offer to also help myself. I'm happy to pay the 6000 pounds to get some parts injection moulded with the hope that we would eventually get the money back over time by selling the feeders to other people who want them. Lots of people here have made feeders and I thought it might be a nice idea to get the best ideas together and design one for injection moulding. Ideally it would be width adjustable and have a couple of options on the hole size for different tapes. Ideally I would like to make 6 pounds profit on the first 1000 sold to recover the cost after that I'm happy for them to be sold at cost or near enough.
Any thoughts?
Has this been done?
Should I stop now?
Can this be done?
Robert
This is a bit of an offer to also help myself. I'm happy to pay the 6000 pounds to get some parts injection moulded with the hope that we would eventually get the money back over time by selling the feeders to other people who want them. Lots of people here have made feeders and I thought it might be a nice idea to get the best ideas together and design one for injection moulding. Ideally it would be width adjustable and have a couple of options on the hole size for different tapes. Ideally I would like to make 6 pounds profit on the first 1000 sold to recover the cost after that I'm happy for them to be sold at cost or near enough.
Any thoughts?
Has this been done?
Should I stop now?
Can this be done?
Robert
