PnP Head, Step 7: Attach head lower assembly to Z MakerSlide

Look at the picture below. Slide first one M5 extrusion nut (1) to the indicated slot and two M3 extrusion nuts (2) after that; we’ll need these later. Attach the motor assembly to the MakerSlide in the orientation shown, using two HTJ5 self-tapping screws (3) and M5 washers (5):

PnP head step 7

  1. M5 extrusion nut
  2. M3 extrusion nut x 2
  3. HTJ5 screw x 2
  4. M5 washer x 2

Previous Next

Back